Shower Water Softener for Hard Water | Hera Aqua

• Softer Skin
• Reduces dry scalp and hair fall
• Reduces chances of eczema flare-ups
• Less soap scum
  
  

• Easy to install. No drilling and no plumber required.
• Sleek and Stylish design
• Mega-sized softener cartridge filled with expert-formulated resin beads to give the best softening results without compromising water pressure
  
  

• Height: 360mm
• Width: 108mm
• Depth: 106mm

• 1 full resin filter catridge
• 1 set of wall mount
• 2 pairs of adhesive hooks
• 1 aluminium case to give it a sleek look
• 1 hose with a quick fastener
• 1 set of regeneration equipment ( a salt water tank, a regeneration adaptor, a USB cabled water pump*)

* the water pump can be plugged into a power bank directly or into a socket via a USB adapter. Power bank and USB adapter NOT INCLUDED

To keep your water softener performing at its best, regenerate the cartridge every 2–4 weeks using salt and water. Under normal water conditions, the cartridge can last up to 2 years.

Regeneration Steps

1. Prepare the regeneration tank – Fill the tank with tap water.
   
2. Add salt – Pour in approximately 500 g of regular table salt (any type of salt is fine—just avoid sodium-free varieties).
   
3. Remove the softener cartridge – Twist the cartridge off the wall mount adapter.
   
4. Attach the regeneration adapter – Secure it onto the cartridge.
   
5. Insert the cartridge into the tank – Place it into the cartridge slot inside the tank.
   
6. Position the pump – Submerge the water pump in the salt water and use the suction cups to keep it at the bottom of the tank.
   
7. Set up the drain – Direct the small outlet tube from the regeneration adapter toward a suitable drain (e.g., kitchen sink, shower drain, or a bucket).
   
8. Start regeneration – Plug the pump into a power source (such as a power bank or wall socket) to begin the regeneration process.
   

Note: power bank and USB socket adapter are not included.